Friday, May 5, 2017

Abnormally Long First Boot Times on Cisco 3750x's with 15.2.x code



I recently upgraded some Cisco 3750x (WS-C3750X-48T-S to be precise) from 12.2.x code to 15.2 code (15.2(4)E4.)

The reboot took a rather long time due to microcode updates. It was about 25-30 minutes. The following messages were displayed:



ssssssssspssssssssssssssssssspssssssssssssssssssspssssssssssssssssssspssssssssssssssssssspsssssssssp
Front-end Microcode IMG MGR: Preparing to program device[0]...25166 bytes.
Front-end Microcode IMG MGR: Programming device 0...rrrrrrwssssssssssssssssssspssssssssssssssssssspp
Front-end Microcode IMG MGR: Preparing to program device[0]...86370 bytes.
Front-end Microcode IMG MGR: Programming device 0...rrrrrrwssssssssssssssssssspssssssssssssssssssspw

% Front-end Microcode IMG MGR: HW image is upgraded. MCU reset causes the switch to reload

If you're making such an upgrade, be prepared for a long wait. It will likely be worse on a stack.

While the 3750x is not a speedy switch, management-wise, this was impressively slow. The regular boot time after the upgrade was about 5-6 minutes, so be patient. Switches in a stack will take even longer to boot.

1 comment:

Unknown said...
This comment has been removed by the author.